Pulse Setup Not connected

Connect to a Pulse

Wake the device, keep your phone within a couple of metres, then pick it from the Bluetooth list.

  1. 1Connect over Bluetooth
  2. 2Enter the admin PIN
  3. 3Review the device check, then finish

Enter the admin PIN

The PIN is used for each command and is forgotten when you finish or close this page.

Connected device

Pulse

Run the device check to read its status.

Ask the device

Read-only

Each button sends a command to the Pulse and shows its reply. Nothing on the device changes.

Full status Hardware, firmware, battery and timers
Sensor pairing Which WS1001 / LoRa sensor is paired
SLI slots What is plugged into the two sensor ports
Data destination Which server type the Pulse uploads to

SIM control

Check SIM slots

Read-only

Scans both slots and shows the card number (ICCID) found in each.

Detect SIM cards Takes about a minute

Switch SIM

Changes device

Pick a slot, then tap one of the buttons to send the command.

Tap “Scan” above to see which slots are populated.

Device actions

Sensors & data

Read-only

Take a reading or look at what is waiting to be uploaded.

Read sensors Take a sample from the connected sensors
Upload queue Records waiting to be sent

Upload

Uses cellular

Turns the modem on and sends the queued records now. Takes one to two minutes.

Send by cellular Upload queued data to the server
Advanced maintenanceLog level, firmware, pairing reset, bootloader

Device log level

Changes device

How much detail the Pulse prints. Choose a level, then tap Apply.

Firmware

Read-only

Shows the running firmware and both stored firmware banks.

Firmware banks Takes about 15 seconds

Danger zone

Changes device

These ask for confirmation before anything is sent.

Forget paired sensor Removes the WS1001 pairing
Enter bootloader Restarts into firmware-update mode

Device log

Device activity will appear here.

Result

Running

Are you sure?